Rheem PVCG Uživatelský manuál stáhnout pdf

TECHNICAL SERVICE DEPARTMENT

Technical Service Bulletin

1-800-432-8373

Concentric Vent Termination Kit - Installation Instructions

Technical Competence, Product Confidence

Page 1 of 7

1714.doc

Advantage Plus

Concentric Vent Termination Kit SP12161 (3”)

Read this entire instruction manual before starting the installation!

INTRODUCTION

These instructions cover the installation of the concentric vent termination kit –SP12161 (3”) on

all 160,000 and 199,00 BTU Advantage Plus high-efficiency gas fired water heaters.

NOTE: If these instructions differ from those packaged with the advantage plus unit, follow

these instructions.

SAFETY CONSIDERATIONS

Installing and servicing heating equipment can be hazardous, due to gas and electrical

components. Only trained personnel should install or service heating equipment. All operations

should be performed by trained service personnel. When working on heating equipment, observe

all precautions in the literature, on tags, and on all labels attached to the unit. Follow all safety

codes; wear safety glasses and work gloves; have a fire extinguisher available.

______________________________________________________________________

WARNING: BEFORE BEGINNING ANY INSTALLATION OR MODIFICATION, BE

SURE THE MAIN ELECTRICAL DISCONNECT SWITCH IS IN THE “OFF” POSITION.

ELECTRICAL SHOCK CAN CAUSE PERSONAL INJURY OR DEATH.

______________________________________________________________________

DESCRIPTION AND USAGE

The part number SP12161 (3”) can be used for 3” diameter pipe systems. See Fig. 3, 5, 6, and 7

for the different applications. Both combustion air and vent pipes must attach to the termination

kit. The termination kit must terminate outside the structure and must be installed as in one of the

installations shown in Fig. 3, 5, 6, or 7; roof termination is preferred.

WARNING: THESE KITS ARE TO BE USED ONLY FOR THE TERMINATING THE

ADVANTAGE PLUS UNIT. DO NOT USE KIT TO TERMINATE CATEGORY I, II, OR III

WATER HEATERS. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN FIRE,

PERSONAL INJURY, OR DEATH.

Field supplied pipe and fittings are required to complete the installation. The combustion air and

vent pipe fittings must conform to American National Standards Institute (ANSI) and American

1 2 3 4 5 6 7